Due to COVID-19, call volumes are very high and there is no guarantee you will be connected. You can find a lot of great information here on our Help Center, but if you can’t find what you’re looking for we recommend sending us an email and we will respond as soon as we can.

RadRunner LED Display Replacement Guide

The RadRunner LED display can be replaced in the unlikely event it is damaged or determined to be non-functional by Rad Power Bikes Product Support.

Follow the steps below to replace the LED display on a RadRunner. If you want to upgrade the display to the LCD display, click HERE to purchase and HERE for installation steps.

Tools Needed:

  • 3 mm Allen wrench
  • Flat side cutters
  • A few zip ties
  • The replacement display from Rad Power Bikes
  1. Get the bike ready for maintenance. Turn off the bike, remove the battery, and press and hold the power button to discharge remaining power.

    Turn_off_bike.gif
  2. Locate the display connector. Trace the cable coming out of the display to the silver metal connector.

    Locate_display.gif
  3. Unplug the connector. Use flat side cutters to snip the zip tie. Twist each side of the silver metal  connector until the threaded portion releases fully and then pull each side of the connector directly apart, without twisting, to unplug.

    Unplug_display.gif
  4. Remove the display from the handlebar. 
    1. Use a 3 mm Allen wrench to remove the display clamp bolt.

      Remove_bolt__2_.gif
    2. Open the display clamp and remove the display from the handlebar. Recycle the display according to local rules.

      Remove_display.gif
  5. Install the new display. 
    1. Pass the new display clamp over the handlebar.

      Install_new_display.gif
    2. Thread in the bolt by hand and use a 3 mm Allen wrench to tighten the bolt partway. Adjust the display so it is in the proper position for a rider to use and then tighten the bolt securely. The display should not move once tightened securely.

      Reinstall_bolt.gif
    3. Plug in the display connector. Line up the internal notch and pins (and external arrows) and press each side of the connector directly together, without twisting, to reconnect. Then twist just the silver metal portion until the connector is fully secure.

      Plug_in_display.gif
    4. Replace any snipped zip ties and trim them to be flush and smooth.

      Zip_ties.gif
  6. Reinstall the battery and test the bike fully before riding.
Caution.png If you are not confident in your ability to successfully and safely perform all steps, we recommend having the work performed by a local, certified, and reputable bike mechanic.

 

Need more assistance?  Submit a request