Due to COVID-19, call volumes are very high and there is no guarantee you will be connected. You can find a lot of great information here on our Help Center, but if you can’t find what you’re looking for we recommend sending us an email and we will respond as soon as we can.

RadRunner Center Console Installation Guide

The RadRunner center console is compatible with the RadRunner 1 and RadRunner Plus. The kit comes with the console and hardware. Use the instructions below to install the console.


How Big is the Center Console?

The center console can hold up to 22 lb (10 kg) of cargo. Do not exceed the recommended weight or injury or damage may occur. Take a look at the image below to see how much you can fit in the center console.

Center_console.png


Install the Center Console

Tools Needed:

  • 4 mm Allen wrench
  • Torque wrench
  1. Remove the mounting bolts on the frame. Use a 4 mm Allen wrench to remove the bolts from the four mounting points on the bike frame.

    mounting_points_circled.png  
  2. Place the center console into position. Align the holes in the bottom and front of the console with the mounting points on the frame.
  3. Get the hardware ready for installation. Pass washer onto a bolt, and then insert the bolt through the console and into the mounting point on the frame. Tighten loosely by hand. Repeat for all four mounting points. Use a 4 mm Allen wrench, to tighten the four bolts evenly. Torque to 4 Nm. Do not overtighten.

    P1001394.jpg   P1001396.jpg
  4. Secure the lid. Stretch the straps over the mounting points on the front and back of the console.

    P1001412.jpg
  5. Test the bike fully before riding, and ride Rad!
Caution.png If you are not confident in your ability to successfully and safely perform all steps, we recommend having the work performed by a certified and reputable local bike mechanic.

 

Need more assistance?  Submit a request